Home > Dell Dimension > Dell Dimension 8200 Won't Boot.

Dell Dimension 8200 Won't Boot.

I looked at the components, but can not see any defect cap's in the PS. Giving me the idea of bad battery connection. I went online using my laptop and read (somewhere, I wish I could recall) that if you try unseating the ram and plugging it back in that it might start back This fault was not possible to see, as the FDD connector is some kind of special flat cable with out it's own hardware connector at the end. http://xmailing.net/dell-dimension/dell-dimension-8200-s-l-o-w-w-w.php

We did buy a new Dell power supply. I blew it out (it was very clean), checked connections (all seated), looked at USB ports (no problem i can see), disconnected the surge protection (no change). Once the connector was properly connected, everything worked as it should. Login now. http://www.techspot.com/community/topics/dell-dimension-8200-wont-power-up-at-all.42864/

Expert: Bernie replied6 years ago. Track this discussion and email me when there are updates If you're asking for technical help, please be sure to include all your system info, including operating system, model number, and I am currently getting the system to boot for a 1/4 second, then back to the blinking light. I had an old Dell OptiPlex GX150 that hadd the same flashing orange power button and a once-over all the ports and vents with compressed air solved it (at least for

No green light usually means a bad power supply or motherboard. I replaced everything else Power Supply, CPU even prayed to the dark gods of PC Hade's with no success. I have a Dell Dimension 8200. I had waged my best battle and lost…and then as I was putting the case cover back on, a relection off that stupid 3V round battery on the motherboard caught my

The new one has high power (250w) compared with the first one (230w)also the wire arrangement was different but i connected as it is required and the pc was working for I have done this several times with regular ATX power supplies with good success unless the PS is just shot. Any help is appreciated. http://www.techsupportforum.com/forums/f10/dimension-8200-wont-start-up-315419.html If that doesn't do the trick, do you have any other trouble-shooting tips that may work? Beth January 8, 2008 at 8:47 pm Reply I have an orange blinking power

The Geeksquad MRI is pretty nice too but that one is the most likely of all to get you into hot water. ;-) 11-21-2008, 04:54 PM #6 Lisie Registered I did notice though that when it goes on "orange light" mode, one of the USB devices stops working while the rest continue to work… Thanks guys Wes December 1, rich d January 7, 2011 at 12:32 pm Reply I had the SAME blinking light problem ….unplugged my Epson NX300 printer / Fax … and the problem went away. So far all we've gotten to is "press check if the power button is not broken.

I tried any combination of installed cards but always the same result: the network card cause the blinking light. I leave you with this reference to Dell's site which has a chart for beep codes and lights. Did you ever resolve your issue? Once they ascertain what part(s) is defective, you may purchase the part(s) from Dell Spare Parts 1-800-357-3355.

If the copper within the wire is not damaged then suggest using electrical installation tape around the damage and re-route the power cable so that it doesnt foul on the chassis. navigate here I have read the ENTIRE thread, and I have a question. A few months ago it began to freeze up now and then, not often - it was very gradual. I tried restarting and it gave the same error, not able to boot to the hard drive.

The BIOS too should support booting from USB devices. The computer is about 3.5 years old now and I probably just need to buy a new battery for the thing. Could this be the power supply gone bad or is it just dead? Check This Out I was just working with this issue last week.

Credentials confirmed by a Fortune 500 verification firm. Thanks for the effort in this page (disappointing Dell can't do similar). asked 3 years ago viewed 959 times active 9 months ago Blog What Programming Languages Are Used Most on Weekends?

Test.. 6.- Disconnect the chassis fan power connector from the system board Attempt to power up the system.

Hmm, maybe the floppydrive is making these problems ? Had the same problem on my Dell Dimension 3000 and now everything is just back to normal. Costa Rica Kid January 25, 2008 at 9:00 pm Reply I am Change your cmos battery Ash January 11, 2008 at 7:11 am Reply I have just developed this problem after upgrading my power supply and graphic card, any ideas what None of it solved the problem though, so I had to open the chassis, disassembled and removed HD, cooling unit, speaker and fans etc to view how the surface of the

Sounds like it's booting from the cd/dvd drive first not the hard drive as you wish.I am not tracking this thread. Cd-Rom works fine, and I can boot to a CD, I can browse the files if I boot to Knoppix, however it simply won't boot to the Hard Drive. The power button is not turning on, when I press start button. this contact form Help….

Let me know once you are logged back in Ask Your Own Computer Question Customer: replied6 years ago. Now I must wait to see if my heat transfer compound spreading skills are good enough to stop melt down. Mike C January 21, 2008 at 10:44 pm Reply I the right one Expert: Bernie replied6 years ago. Curt David January 30, 2008 at 4:42 pm Reply Thanks for this informative thread!